I just started going out and doing estimates for a co. I work for. So I'm sure I will have alot of questions I will be asking. I admit I have alot to learn, but look forward to the new challenge. Its nice to have a place to ask questions and get a second opinion. 1) If you have an outdoor meter base that feeds an indoor panel, shouldn't there be overcurrent protection either outside at the meter base or where the service entrance conductors enter the building? The conduit coming from the meter base runs about 50' inside the warehouse before it lands at the panel. Isn't this a code violation?
Service disco. needed?
- Thread starter Chong
- Start date
- Status
ryan_618
Senior Member
- Location
- Salt Lake City, Utah
Re: Service disco. needed?
It doesn't need overcurrent protection, but it does need a disconnect.
It doesn't need overcurrent protection, but it does need a disconnect.
hurk27
Senior Member
- Location
- Portage, Indiana NEC: 2008
Re: Service disco. needed?
What about 230.90-230.91?
Huh?
What about 230.90-230.91?
ryan_618
Senior Member
- Location
- Salt Lake City, Utah
Re: Service disco. needed?
I was thinking you could have the disco outside and the OCPD inside. I've never seen it done that way, but I was thinking you could do it. Doh!
[ March 23, 2005, 06:50 PM: Message edited by: ryan_618 ]
Um...they don't count
I was thinking you could have the disco outside and the OCPD inside. I've never seen it done that way, but I was thinking you could do it. Doh!
[ March 23, 2005, 06:50 PM: Message edited by: ryan_618 ]
- Status