Setting Equipment

[Alwayslearningelec]

I have a load bank with below weight and dims going on grade outside. Could a Lull move this in place if ground is very firm or concrete?


Packaged Weight 2040.00 lbs (925.33 kg )
Dimensions 77 x 99 x 52 in (185 x 238 x 125 cm)

 

[roger]

Yes and there are different sizes of Lulls

 

[infinity]

Lulls can move large amounts of weight as Roger noted depending on their size. It might not be the best equipment to move a load bank especially one that's only 2000 pounds.

 

[Alwayslearningelec]

Maybe back truck with lift gate up to or near area of final location???

 

[infinity]

Maybe back truck with lift gate up to or near area of final location???

That would work. Is this a permanent load bank?

 

[Alwayslearningelec]

That would work. Is this a permanent load bank?

Yes

 

[busman]

Will it be on a pallet or have fork pockets?

Mark

 

[Alwayslearningelec]

Will it be on a pallet or have fork pockets?

Mark

Not sure.....

 

[infinity]

Yes

These are typically mounted on the generator so it would need to be lifted into place. Also you should check because these are often installed by the tin knocker not the electrician.

 

[Alwayslearningelec]

These are typically mounted on the generator so it would need to be lifted into place. Also you should check because these are often installed by the tin knocker not the electrician.

It's stand alone and not genset mounted in this case.

 

[Joethemechanic]

Here is a 644 Lull load chart. This is your typical 6,000 LBS machine. Although all machines will have their own

 

[zbang]

Almost any telehandler* could move a 1 ton load without breaking a sweat.

* Lull is an old trade name and is unknown in parts of the country; the machine is also known in some places as a "shoot-boom" or "long-each" lift; many are made by Genie and JCB .

 

[Joethemechanic]

Almost any telehandler* could move a 1 ton load without breaking a sweat.

Yeah well that all depends on how far out (radius) and how high. Lots of times I've had them get light in the ass end with less than a ton on them. I made the lift, but I probably shouldn't have