Roy Thomson
Member
- Location
- Fort Worth, TX
Where is Structural integrity discussed in the NEC or in the 29CFR Part 1926 OSHA book ?
''Structural Integrity''
- Thread starter Roy Thomson
- Start date
- Status
jxofaltrds
Retired ESI
- Location
- Mike P. Columbus Ohio
- Occupation
- Creator
Are you asking where you can drill/notch studs, joists etc?
Not sure what you are asking.
Roy Thomson
Member
- Location
- Fort Worth, TX
Structural Integrity
Structural Integrity
I suppose i am refering to drilling & notching wall or ceiling studs ( members ). Where in the NEC is it ? or is it an OSHA item ?or maybe a General Construction item ?
Structural Integrity
I suppose i am refering to drilling & notching wall or ceiling studs ( members ). Where in the NEC is it ? or is it an OSHA item ?or maybe a General Construction item ?
jxofaltrds
Retired ESI
- Location
- Mike P. Columbus Ohio
- Occupation
- Creator
Scoll down the page for floors
R502.8 Drilling and notching.
Structural floor members shall not be cut, bored or notched in excess of the limitations specified in this section. See Figure R502.8.
FIGURE R602.6(1) NOTCHING AND BORED HOLE LIMITATIONS FOR EXTERIOR WALLS AND BEARING WALLS FIGURE R602.6(2) NOTCHING AND BORED HOLE LIMITATIONS FOR INTERIOR NONBEARING WALLS
Note that these are for 'normal' lumber.
kwired
Electron manager
- Location
- NE Nebraska
- Occupation
- EC
Only thing NEC mentions is protection of wiring methods to be installed in the holes or notches. How structural integrity is effected is a building or other code issue and not an NEC issue.
- Status