I have a customer that has a Service with 4-200A 120/240volt single phase Disconnects and one 200A 3ph Disconnect on a gutter where each disconnect feeds a 200A Panel inside building. They requested to have Surge protectors installed on each panel. My question is can I just install A Type 2 surge in each panel on a 2pole breaker or would i need to install Type 1 Surge protector also on each Disconnect as well.
Type 2 Surge protectors
- Thread starter wmeek
- Start date
- Status
letgomywago
Senior Member
- Location
- Washington state and Oregon coast
- Occupation
- residential electrician
That meets the 2020 code
ramsy
Roger Ruhle dba NoFixNoPay
- Location
- LA basin, CA
- Occupation
- Service Electrician 2020 NEC
Type 1 meter adapter SPD has several advantages for single-phase services.
- Location
- Illinois
- Occupation
- retired electrician
Some utilities do not permit customer owned SPDs on the line side of the service equipment.
This is from their service manual:
ramsy
Roger Ruhle dba NoFixNoPay
- Location
- LA basin, CA
- Occupation
- Service Electrician 2020 NEC
Since too many customers install meter adapter SPD without permission, our utility also revoked authorization for everyone, and now remove them whenever found.
Type 1 SPD is still available in other forms when utility is involved in the process.
- Location
- Illinois
- Occupation
- retired electrician
I think it is more based on revenue...when they are utility owned it is an added charge on your monthly bill.
ramsy
Roger Ruhle dba NoFixNoPay
- Location
- LA basin, CA
- Occupation
- Service Electrician 2020 NEC
Maintaining a utility side SPD may cost less than multiple sub-panel types, especially if utility replaces them after sacrificial events.
- Status