lightolier 1103r

[sparky1118]

Has anyone heard of an LED retro trim for a 6" lightolier with the floating socket?

Sent from my SM-G975U using Tapatalk

 

[peter d]

They exist but are very expensive. Your best bet is to install Sylvania's retrofit sleeve for the Lightolier housings and use a regular LED trim.

 

[sparky1118]

I am wondering if a 6" LED wafer light will work with the existing hole. Since there isn't a can and just a housing

Sent from my SM-G975U using Tapatalk

 

[MNSparky]

Just did a job where we retrofitted 130 existing Lightoliers with floating sockets to these:

http://www.cooperindustries.com/con.../spec_sheets/halo-ml7bxrfk-td518136en-sss.pdf

Then we installed these:

http://www.cooperindustries.com/con...halo/spec_sheets/halo-lt56-td518042en-sss.pdf

Turned out great, made a lot of money!:thumbsup:

 

[peter d]

Just did a job where we retrofitted 130 existing Lightoliers with floating sockets to these:

http://www.cooperindustries.com/con.../spec_sheets/halo-ml7bxrfk-td518136en-sss.pdf

Then we installed these:

http://www.cooperindustries.com/con...halo/spec_sheets/halo-lt56-td518042en-sss.pdf

Turned out great, made a lot of money!:thumbsup:

The Sylvania retrofit rings are about $5 at the wholesaler and install faster than those Halo retrofit cans.

 

[sparky1118]

Thank you. I was able to use a Westinghouse retro fit LED trim. How I made it work was I bent the clamps down about 90⁰ and they held perfectly snug!

Sent from my SM-G975U using Tapatalk