PPPPPP
- Thread starter 480sparky
- Start date
ptonsparky
Senior Member
- Occupation
- Electrical Contractor
Yea, they're missing a strap. Hacks.
- Location
- Placerville, CA, USA
- Occupation
- Retired PV System Designer
Only using up 270 degrees though...
- Location
- Chapel Hill, NC
- Occupation
- Electrical Contractor
Of all the things we see that is what bothers you.... hahaha
hillbilly1
Senior Member
- Location
- Atlanta,Ga
I had a guy that would bend pipe like that, wouldn't even use a bender, he would bend it around the back of his neck. Claimed that's how they did it on oil rigs........
- Location
- New Jersey
- Occupation
- Journeyman Electrician
With 5 EMT's I'm guessing that box fill probably didn't matter either.
Carultch
Senior Member
- Location
- Massachusetts
What's a tin-knocker, 480?
- Location
- New Jersey
- Occupation
- Journeyman Electrician
Someone who installs metal ductwork. Aptly named because they're costantly hitting it with a hammer
.Eddie702
Licensed Electrician
- Location
- Western Massachusetts
- Occupation
- Electrician
No LB or flex in the truck
Buck Parrish
Senior Member
- Location
- NC & IN
Probably had the wire in it whilst bending it. But.. How would I know
ptonsparky
Senior Member
- Occupation
- Electrical Contractor
They do have those fancy little bending tools. That EMT bends a lot harder then line sets.Probably had the wire in it whilst bending it. But.. How would I know
texie
Senior Member
- Location
- Fort Collins, Colorado
- Occupation
- Electrician, Contractor, Inspector
Coppersmith
Senior Member
- Location
- Tampa, FL, USA
- Occupation
- Electrical Contractor
I see four missing straps. There may be a fifth. The picture is cut off. The Shepard's hook looks like it was bent out of the way after the install.
It looks like it was bent using a pallet.
Eddie702
Licensed Electrician
- Location
- Western Massachusetts
- Occupation
- Electrician
It could be worse. He could have used a square cover with a ko in it and gone straight in LOL
That's crazy,,, I just about posted these exact same words yesterday.
Too funny,
JAP>