Pull box sizing!

[AC\DC]

Hello, Small job turned into a panel replacement. My inspector said he would ding me for a existing pull box that was undersized. I am not technically touching it replacing a panel above it. Want to make sure I am sizing it correctly.

Currently it is 3'x6" I get 3'x16.25" The distance from raceway conductors sharing same conductor will be greater than (2x6) 12" so I was not worried about the Length its more enough I believe.

could not find any exception for nipples since the whole top section is under 2'

See anything wrong with this. going through my book right now. Thank you guys.

 

[LarryFine]

My inspector said he would ding me for a existing pull box that was undersized. I am not technically touching it replacing a panel above it.

Sounds like it shouldn't be involved in the scope of work at all.

 

[AC\DC]

Ya, that what i felt . It is a tight box though so something good out of it

 

[LarryFine]

It is a tight box though so something good out of it

I . . . must . . . resist!

 

[AC\DC]

He going to ding me for the PVC connector on the top of the 3R enclose not being watertight i bet.

 

[hotneutral]

Is that pull box even bonded?

 

[AC\DC]

It is now

 

[AC\DC]

It was not when I came