Tap

[Alwayslearningelec]

Trying to figure out correct configuration(or close) for tap splice that could be used here. Have 3#1/0 & #6G coming into trough and have two sets of the same sizes leaving the trough.

Think I can use this for the phase conductors?

https://www.ilsco.com/Ilsco/ccrz__ProductDetails?sku=PBTD-9-500-ILSM-ILS&cclcl=en_US

 

[infinity]

Yes those can be used. I know that you mentioned a tap but with the conductors all being the same size what you actually have is a splice.

 

[Alwayslearningelec]

Yes those can be used. I know that you mentioned a tap but with the conductors all being the same size what you actually have is a splice.

Ah, true? So would that change what's being used to join the conductors? Would some sort of splice kit be used instead of tap block?

 

[infinity]

Ah, true? So would that change what's being used to join the conductors? Would some sort of splice kit be used instead of tap block?

Those type of connectors are fine. I just mentioned to tap thing for your own knowledge.