Washer and disposal hook up

Status
Not open for further replies.
F

Farmfly

Member
Location
North Carolina
Occupation
Electrician
Was wondering how you guys like to hook up your dishwasher and disposal hook ups do you hardwire or do you use a appliance whip, do you GFI if I protect? Or what do your inspectors like to see? Thks
 
At the rough in I leave 6' of Romex for the DW, makes it easier for me to install and easier for homeowners to replace in 5 years. I install a receptacle for disposal and use whip. Both on same circuit, gfi breaker
 
865resi said:
At the rough in I leave 6' of Romex for the DW, makes it easier for me to install and easier for homeowners to replace in 5 years. I install a receptacle for disposal and use whip. Both on same circuit, gfi breaker
Click to expand...
Does your inspector require a dual function GFCI/AFCI breaker for this circuit?
 
NTesla76 said:
Most contractors around here will have a duplex receptacle under the sink on an individual 20 amp circuit. Split the receptacle and have a cord for the disposal and a cord for the dishwasher. I'm sure depending on amps, it isn't quite code compliant sometimes, but we allow it.
Click to expand...
I see that as perfectly fine as long as neither appliance exceeds 10 amps (equipment fastened in place. 210.23 (A)(2) I still see the circuit needing both GFCI and AFCI protection.
 
Rick 0920 said:
I see that as perfectly fine as long as neither appliance exceeds 10 amps (equipment fastened in place. 210.23 (A)(2) I still see the circuit needing both GFCI and AFCI protection.
Click to expand...
Recent job the inspector red tagged it and he was correct. IIRC it was a 3/4 hp disposal, told HO to go grab a 1/2 HP and it worked with that. So yeah just be careful putting dish and disposal on the same circuit.
 
electrofelon said:
It is code required not inspector required to have afci and GFCI. If I may make a suggestion, get in the habit of doing what the code says, not what an inspector says/prefers/ wants to see.
Click to expand...
That's what I was getting at. I was asking the OP if his inspector was complying with the NEC. Thanks.
 
I always pull a circuit for the DW. Bosch and Viking (+ others) like to put booster heaters in. I set a handy box with recep at rough, so there's two recep's hot during rough. Then just put a cord on at install. Received a red tag in the early '90s for using romex to the appliance, I never did it again.
 
electrofelon said:
Recent job the inspector red tagged it and he was correct. IIRC it was a 3/4 hp disposal, told HO to go grab a 1/2 HP and it worked with that. So yeah just be careful putting dish and disposal on the same circuit.
Click to expand...
Same here I think its under 430.53 that the motor has to be 6 amps or less. 10A or less for the dishwasher per 210.whatever.
 
On a new build I prefer to put them each on their own these days, then if you have a GFCI/AFCI/ breaker issue its less of a puzzle.
 
jimC. said:
Received a red tag in the early '90s for using romex to the appliance, I never did it again.
Click to expand...
I wonder why. We always run NM to the dishwasher and NM in 1/2" FMC to the disposer.

I have never installed, nor even seen a cord-connected dishwasher or disposer.
 
Status
Not open for further replies.
Top